Tiger Products Co., Ltd JD 5083E User Manual download pdf (Page 40)

Assembly Section 2-6

ASSEMBLY

JOYSTICK SWITCH BOX WIRING

Refer to the parts section for the danfoss wiring schematic to hook up the switch

box. Cover all wires with plastic wire wrap provided. Route the green wires along

switch box bracket and cab frame to the steering wheel console. Route the rest of

the wires along the base of the right hand console and up to the rubber boot in the

bottom right corner in the rear window of the cab. The red and black wires will be

connected to the auxillary power plug in the back of the cab. After all wiring is

complete, secure all wires to the console with zip ties and push mounts. Take up

most of the slack so the wires are out of the way and tighten the zip-ties.

With the panel under the steering wheel removed to access the wires, locate the

brown wire and verify that this is the neutral safety wire with a test light or meter.

Then cut the brown wire and connect a green wire from the switch box to each end

of the brown wire as shown in the wiring diagram. Cut a small hole for the green

wires and the wire wrap to fit through and replace the console.

The red and black wires access power for the switchbox through a John Deere

auxillary power plug in the rear of the cab.

NOTE: The RED wire from the JD power plug should not be used because it

is ALWAYS “Hot”. +12 VOLTS ELECTRICAL POWER MUST BE TAKEN FROM

A SOURCE LOCATION WHERE IT IS LIVE ONLY WHEN THE IGNITION

SWITCH IS IN THE “ON” POSITION. THE RED WIRE MUST BE FUSED AT

THE SOURCE LOCATION WITH A CLOSED END CONNECTOR (# 34538).

Connect the red wire from the switch box to the orange wire from the JD power plug.

Connect the black wire from the switch box to the black wire from the JD power plug.

Two sets of wires have Metri-Pak ends on them. The white anb black wires plug

into the brake valve. The orange and black wires plug into the travel lock.

Cut a cross hair pattern in the rubber boot in the right bottom corner of the rear

window. The wires can be routed through and the rubber falls back into position.

The hole should only be large enough for the wires to go through easily.

Route the Metri-Pak wires from the window boot to their location on the unit. Coil

the excess wire and secure it to the tractor frame with zip ties to eliminate vibration

and rubbing.

NOTE: When cutting or drilling a hole, be sure not to damage existing wires running

behind panels.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 181 182

No comments

Tiger Products Co., Ltd JD 5083E User Manual Page 40