Tiger Products Co., Ltd JD 5083E User Manual download pdf (Page 43)

Assembly Section 2-9

ASSEMBLY

DANFOSS VALVE PLUMBING

(WITH MID-MOUNT VALVE)

A priority valve will be used to power the danfoss lift valve. The tractor ports used

are on the selective control valve (SCV) and the Mid-Mount Valve. The SCV is located

between the right arm of the three point hitch and the axle. The Mid-Mount valve is

located under the right front corner of the cab. The power beyond port is located on

the bottom of the Mid-Mount valve towards the front. The excessive flow port is

located on the underside of the SCV. The return port is accessed through the end of

a run tee located on the SCV. See the danfoss lift valve page in the parts section for

hardware and location of parts. Refer to the image below as a guide.

The power beyond port uses the existing adapter for the pressure hose. That

hose is routed to the “P” port of the priority valve. Next the hose from the “CF” port

on the valve goes to the “P” port on the danfoss lift valve. The return hose from the

lift valve is connected to the closest end on the run tee of the “T” port on the selective

control valve. Plumb the excessive flow hose from the “EF” port on the priority valve

to the “EF” port on the SCV. Then the load sense hose goes from the “LS” port on

the priority valve to the “LS” port on the lift valve. Refer to the illustration below for port

call-outs on the danfoss priority valve.

SCV

MID-MOUNT VALVE

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 181 182

No comments

Tiger Products Co., Ltd JD 5083E User Manual Page 43