Tiger-products-co-ltd TWR-180 User Manual download pdf (Page 26)

Introduction Section 2-2

INTRODUCTION

TWR-180 / TWR-120 12/04

Your heavy-duty Cutter is designed primarily for weeds, grass, and brush up to 2" in diameter. With proper

maintenance as described in this manual, your Cutter will provide you with years of dependable service with a

minimum of repairs.

It is required that all operators of this implement read this manual or be instructed of its contents as to safety,

proper operation, and maintenance before beginning operation.

Your Cutter has been assembled for operation with a tractor PTO input speed of either 540 or 1000 RPM. Should

you desire to change PTO input speed, contact your local Tiger dealer who will assist you in performing the

necessary modifications.

When ordering parts for the Gearboxes and the Drivelines, be sure to specify the serial number. The serial number

is located outside of the right Tongue attaching Plate on the center Mainframe section.

Chain Guards, Driveline Integral Shields, and Gearbox Shields are standard equipment and are to be used at all

times.

To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail

promptly. Be sure to give the serial number of this Cutter.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 85 86

No comments

Tiger-products-co-ltd TWR-180 User Manual Page 26