Tiger-products-co-ltd TWR-180 User Manual download pdf (Page 32)

Assembly Section 3-6

ASSEMBLY

TWR-180 / TWR-120 12/04

CAUTION!

Use FLASHING WARNING LIGHTS when traveling on public roads day or night,

unless prohibited by law.

Transport Light Kit

If the rotary cutter obscures the tractor warning or tail lights, the rotary cutter MUST be equipped with a transport

light kit.

Check local highway regulations concerning moving machinery on highways.

Installation of Lights

Secure the cutter into transport position. Mount the brackets to the center beam as shown in the illustration, using

the supplied 3/8" U-bolts. The two 4" x 4-3/4" U-bolts are needed for the TWR-180/TWR-120 kit, and the two 5" x

6" U-bolts can be discarded.

Align the outside edge of the brackets with the end caps on either side of the beam. Tighten into place. Using the

5/16" bolts, mount the lights to the brackets with the red and amber lenses facing to the rear, and the amber in the

outer-most left and right positions. When the cutter is in transport position, the light assemblies should be sitting

vertical on the center beam.

Wiring Harness

The seven pin plug and wiring harness is pre-wired with the 7' leg to attach to the left hand light assembly and the

4' leg to attach to the right hand light assembly. Left and right hand is determined by standing at the rear of the

cutter looking in the direction of normal forward travel. The wiring harness plugs are colored coded for connection

to the appropriately colored lamp.

Using the cable ties, route the harness along the hydraulic hoses to the front of the cutter Allow enough slack in

the harness for the up and down movement wings. There should be approximately 5' to 6' of harness extending

past the hitch point for connection to the tractor.

Circuit Testing

The seven pin plug is wired as follows:

The lights should operate in unison with your

tractor lights.

Terminal 1 Ground

Terminal 3 LH Turn & Flash

Terminal 5 RH Turn & Flash

Terminal 6 Tail Lamps

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 85 86

No comments

Tiger-products-co-ltd TWR-180 User Manual Page 32