Tiger-products-co-ltd TWR-180 User Manual download pdf (Page 30)

Assembly Section 3-4

ASSEMBLY

TWR-180 / TWR-120 12/04

Center Wheel Standard Spacer Plates

On the center section, spacer plates are required between the

cylinder lug and its mount plate. The spacer plates allow the transport

and cut heights to remain consistent between tire sizes and or blade

configurations. Spacers are be preset at the factory, however if blade

type or tire type change, so may the spacers. Consult the following

chart:

Driveline Shield Chains

Attach CV shield chain to tractor or cutter hitch allowing sufficient slack for turning.

IMPORTANT: OSHA, ASAE, and SAE standards require that all rotating shafts be guarded against contact. The

unchained plastic shields can rotate with the driveline but must stop when they contact another object, (Note:

these shields may also be chained.)

The shields must be regularly greased and checked that they rotate freely on the driveline. Refer to the Lubrication

section for greasing intervals.

Laminated Tires

To reduce the possibility of the laminations separating, the

laminated tires should be installed with the laminations

oriented as shown.

Adjustable Skids

When installing the material distribution

kit, the adjustable skids on the center frame

and the wing frames should be set in the

lowest positions.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 85 86

No comments

Tiger-products-co-ltd TWR-180 User Manual Page 30