Tiger Products Co., Ltd JD 5083E User Manual Page 47
- Page / 182
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Assembly Section 2-13
ASSEMBLY
The rubber boot in the corner of the rear window can be cut in a cross hair
pattern and if necessary the bottom cut through to allow it to slip over the cables and
back into position. These cables will be routed to the lift valve mounted on the valve
mounting plate, and should not have any sharp bends or kinks in them. Secure
cables with zip ties and apply RTV sealer or similar product in and around individual
cables, inside and outside of the cab for a water tight seal. Do not allow excess
cable to hang unsecured on the outside of the cab.
RUBBER BOOT
VALVE CABLES
ELECTRICAL WIRES
WINDOW ROUTING
CABLE CONTROL LEVER STAND (MID-MOUNT UNITS)
Place the cable control bracket on the floor so that the bracket is 2-1/2” from the
side edge of the door, and 4-3/8” in front of the rear edge of the door. See images below.
Be sure that the location of the stand will allow the operation of all control levers in the
tractor and that the door will not strike the stand when shut. Before drilling double check
location of the stand for proper placement of holes. Make sure that all cables and wires
are clear of the area before drilling holes to mount the stand. Drill 3 holes to match
control bracket as shown below and secure with capscrews and nylock nuts noted in
parts section.
- CHEETAH BOOM 1
- ASSEMBLIES 1
- TABLE OF CONTENTS 5
- Cheetah Safety Section 1-1 7
- YOU! Only YOU can 8
- (SG-19) 11
- Cheetah Safety Section 1-15 21
- 00769737 21
- 00725746 21
- Cheetah Safety Section 1-16 22
- 02962764 22
- 02962765 22
- 02965262 22
- Cheetah Safety Section 1-17 23
- 02971123 23
- 03200285 23
- Cheetah Safety Section 1-18 24
- Cheetah Safety Section 1-19 25
- Cheetah Safety Section 1-20 26
- Cheetah Safety Section 1-24 30
- Cheetah Safety Section 1-25 31
- HYDRAULIC TANK 32
- FEDERAL LAWS AND REGULATIONS 34
- ASSEMBLY 35
- TRACTOR PREPARATION 36
- CRANKSHAFT ADAPTER 36
- MAIN FRAME MOUNTING 37
- ADJUSTING REAR WHEELS 37
- POLYCARBONATE SAFETY WINDOW 37
- 3-POINT BOOM REST MOUNTING 38
- AXLE BRACE 38
- JOYSTICK SWITCH BOX MOUNTING 39
- JOYSTICK SWITCH BOX WIRING 40
- JOYSTICK CONTROL MOUNTING 41
- VALVE MOUNTING 41
- DANFOSS VALVE PLUMBING 43
- (WITH MID-MOUNT VALVE) 43
- HOSE AND CABLE ROUTING 48
- CHEETAH HOSE ROUTING 50
- HYDRAULIC TANK INSTALLATION 52
- GENERAL HOSE INSTALLATION 52
- SWIVEL BRACKET MOUNTING 52
- DECK ATTACHMENT 53
- BOOM INSTALLATION 53
- HOSE COVERING 53
- PREFORMED TUBE INSTALLATION 53
- WHEEL WEIGHT MOUNTING 54
- INSTALLING O-RING FITTINGS 54
- MOWER TESTING 59
- 4WD FRONT TIRE ADJUSTMENT 60
- OPERATION 61
- STARTING TRACTOR AND MOWER 63
- JOYSTICK CONTROL SWITCH BOX 64
- JOYSTICK CONTROL 66
- (ON SWITCH BOX) 67
- LEVER CONTROL AND FUNCTIONS 68
- MOWER OPERATION 70
- UNSTOWING BOOM 70
- TRANSPORTING MOWER 72
- INSPECTION SHEETS 74
- MAINTENANCE 79
- MAINTENANCE PRECAUTIONS 80
- BREAK IN PERIOD 80
- REGULAR MAINTENANCE 81
- WEEKLY OR EVERY 50 HOURS 82
- MONTHLY OR EVERY 150 HOURS 82
- YEARLY OR EVERY 500 HOURS 82
- TROUBLE SHOOTING 82
- TORQUE SPECIFICATIONS 84
- LUBRICATION RECOMMENDATIONS 85
- DETAILED MAINTENANCE 87
- GREASING SPINDLE 89
- TIGHTENING SPINDLE BOLTS 90
- GREASING THE BOOM SWIVEL 91
- BALL VALVES 92
- BOOM FLAIL KNIFE REPLACEMENT 93
- THE SPINDLE ASSEMBLY 94
- BEARING INSTALLATION 95
- BEARING ADJUSTMENT 96
- DAILY MAINTENANCE SCHEDULE 97
- JD 5101E - CHEETAH BOOM MOWER 99
- PARTS ORDERING GUIDE 100
- Parts Section 5-3 101
- Parts Section 5-4 102
- Parts Section 5-6 104
- Parts Section 5-8 106
- Parts Section 5-10 108
- Parts Section 5-12 110
- Parts Section 5-13 111
- Parts Section 5-14 112
- Parts Section 5-16 114
- SWITCH BOX AND JOYSTICK 5101E 116
- LIFT VALVE - JOYSTICK CONTROL 118
- CABLE CONTROLS - SCV ONLY 120
- Parts Section 5-24 122
- WHEEL SPACER 126
- WHEEL WEIGHT ASSEMBLY 127
- Parts Section 5-30 128
- CHEETAH BOOM MOWER 129
- Cheetah Common Section 6-3 131
- Cheetah Common Section 6-4 132
- CHEETAH BOOM ARM ASSEMBLY 134
- CHEETAH ROTARY MOWER DECK 136
- CHEETAH ROTARY PIVOT ASY 138
- DAN FOSS VALVE (06502095) 140
- Cheetah Common Section 6-14 142
- ITEM PART NO. QTY DESCRIPTION 143
- Cheetah Common Section 6-16 144
- Cheetah Common Section 6-18 146
- CHEETAH ROTARY MOTOR 148
- ROTARY SPINDLE ASSEMBLY 150
- CHEETAH FLAIL HEAD ASSY 152
- Cheetah Common Section 6-26 154
- CHEETAH FLAIL MOTOR 156
- CHEETAH CYLINDER BREAKDOWNS 158
- BOOM TRAVEL LOCK 164
- BRAKE VALVE TROUBLESHOOTING 165
- Cheetah Common Section 6-39 167
- HUSCO CONTROLS SWITCHBOX 168
- INTENSIONALLY 169
- OPTIONAL PUMP GUARD KIT 170
- TROUBLESHOOTING 172
- Cheetah Common Section 6-46 174
- Cheetah Common Section 6-47 175
- Cheetah Common Section 6-48 176
- WARRANTY 177
- WARRANTY INFORMATION 179
- ONE LAST WORD 180
- YOU. Common sense should 180
- Printed in USA 182
- © Tiger Corporation 182
Related products and manuals for Lawnmowers Tiger Products Co., Ltd JD 5083E
(186 pages)© 2020, manymanuals.com. All rights reserved. | 0.354 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals