Tiger Products Co., Ltd JD 5083E User Manual download pdf (Page 48)

Assembly Section 2-14

ASSEMBLY

HOSE AND CABLE ROUTING

Attach two clamps to the right rear wheel well for proper hose/cable routing. Drill

one hole for each clamp. Use the lower rear corner of the wheel well as an origin for

measuring. The holes should be 10mm or 3/8” reamed to accept 3/8” hardware.

Measure along the back edge of the wheel well 6” from the origin. Use a square

to measure 2 ½” up, from the last mark. Refer to the image below to see the first

hole.

The second hole should run parallel to the bottom edge of the wheel well. Mark

the hole 22” from the origin and 3 ½” from the bottom edge. Use the images below

for reference.

NOTE: DO NOT CUT INTO TUBES / HOSES / WIRES WHEN DRILLING

THROUGH METAL OR PLASTIC!

FIRST HOLE

SECOND HOLE

Place as many hoses in the clamp that will fit without compromising pressure.

Then secure the (2) HOSE CLAMP (06520013) to the holes drilled with (1 EACH)

CAPSCREW,3/8 X 1 NC (21630) and (1 EACH) NYLOCK NUT,3/8 NC (21627). The

hoses that don’t fit into the clamp are to be secured to the others with zip-ties. For

protection of hoses in contact with metal edges, wrap hoses with spit hose sections

and fasten with hose clamps or zip ties as needed.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 181 182

No comments

Tiger Products Co., Ltd JD 5083E User Manual Page 48